advanced_macro
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende ÜberarbeitungNächste ÜberarbeitungBeide Seiten der Revision | ||
advanced_macro [2018/03/27 13:17] – [Accessory notify - ' Okay, if value = 0 / 1'] akuhtz | advanced_macro [2020/05/13 10:53] – [Accessory notify] akuhtz | ||
---|---|---|---|
Zeile 2: | Zeile 2: | ||
In diesem Kapitel werden tiefergehende Erläuterungen zu Makro und Accessory beschrieben. | In diesem Kapitel werden tiefergehende Erläuterungen zu Makro und Accessory beschrieben. | ||
+ | |||
+ | |||
+ | ===== Macro ===== | ||
+ | |||
===== Accessory notify ===== | ===== Accessory notify ===== | ||
Zeile 33: | Zeile 37: | ||
You can switch between INPUT_PULLUP and INPUT_PULLDOWN only in the CV Definitions-Tab. | You can switch between INPUT_PULLUP and INPUT_PULLDOWN only in the CV Definitions-Tab. | ||
- | - Load the CV values from the node (see the steps here) | + | - Load the CV values from the node (see the steps [[wizard# |
- Change the Bit 1 of GPIO port you want to change (press Memorize before store the changes back on the node) | - Change the Bit 1 of GPIO port you want to change (press Memorize before store the changes back on the node) | ||
- Restart of the node is required (use context menü of the node) | - Restart of the node is required (use context menü of the node) |
advanced_macro.txt · Zuletzt geändert: 2023/11/14 09:32 von akuhtz