====== LightControl ====== **BiDiB-Knoten mit dem Schwerpunkt "Beleuchten und Bewegen"** {{ :lightcontrol:lc_produktbild_1.jpg?400 |}} Die LightControl ist ausgestattet mit einem DCC-Interface und mit einem BiDiB-Interface für eine schnellere, sichere und adresslose Kommunikation. Durch eine frei wählbare Portzuweisung (Ausgänge) mit Hilfe des BiDiB-Wizards kann Ihre Anlage zu jederzeit um einen weiteren Effekt erweitert werden. ---- ===== Leistungsmerkmale: ===== * Versorgungsspannung 9V-20V Gleichspannung / 9V-16V Wechselspannung * 16 frei programmierbare Schaltausgänge mit je 300mA * 32 LED-Ausgänge frei programmierbar, Stromquelle, PWM-Helligkeitsregelung * 4 Servoausgänge, Stromversorgung der Servo schaltbar * 8 universelle Eingänge * DCC-Eingang, railcom® * BiDiBus-Anschluß * Universalansteuerport für USB (FTDI) * Platinengröße: 80mm x 100mm * Befestigungslöcher: 3.2mm {{ :lightcontrol:lightcontrol_bemassung.jpg?1000 |}} {{ :lightcontrol:lightcontrol_anschlussbild_2.jpg |}} ---- ===== Firmware ===== Bei der Firmware hat man die Wahl zwischen zwei Versionen: ^ ^ Standard ^ Signal ^ |verwendetes Portmodell | Typ orientiert | Typ orientiert | ^ LED | | | |Anzahl Lightports | 32 | 32 | ^ Servos | | | |Anzahl Servos | 4 | 4 | ^ I/O | | | |Anzahl Eingänge | 8 | 8 | |Anzahl Ausgänge | 16 | 16 | ^ Makros | | | |Anzahl Makros | 40 | 64 | |Anzahl Makroschritte je Makro | 38 | 20 | ^ Accessories | | | |Anzahl Accessories | 20 | 24 | |Anzahl Aspekte je Acc. | 7 | 7 | |Accessories Makromapped | Ja | Ja | ---- Im Downloadfile sind beide Versionen enthalten. Weitere Infos:\\ [[http://opendcc.de/elektronik/lightcontrol1/lightcontrol.html]]\\ [[https://www.fichtelbahn.de/lightcontrol.html]]